Training wheel for Tormek KJ-45 and KJ-140
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
It is a tool that fits over the existing KJ-45 in a snug fit way.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 177
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
You want to teach yourself a new skill, but as a beginner, it is sometimes difficult to pay attention to many things at once. Especially if you are not sure if you are doing things right. To eliminate at least one variable, here is the training wheel for the Tormek KJ-45 and the KJ-140.
For me, it was always difficult to keep the KJ-45 perfectly straight against the guide. The result was an uneven bevel grind, especially with longer blades. The training wheel works just like the wheels on your little bike back in the day. (Don't lie, you had them too!) It is a tool that fits over the existing KJ-45 in a snug fit way. The idea is that once you are fully proficient, you can remove it without damaging the original tool.
Do be careful if you are going to use the training wheel together with the KS-123. With smaller knife blades, there is a chance that the angle cannot be set correctly because the wheel comes into contact with the KS-123.
I printed the parts under a 45° angle in PLA to give them better part strength. Remember, the intention is that you can remove the original tool afterwards without damage. So, first try adjusting any printer settings or using a different filament if the wheel does not fit immediately. You need additional hardware to make this. 2x M4 threaded inserts and 2x M4 screws that are at least 12mm long. Once the training wheel is installed, you can lightly sand the gliding surface of the print if necessary.