Sonance Satellite Speaker PVC Ground Mount Coupler
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mounts Sonance outdoor satellite speakers directly to ¾" Schedule 40 PVC pipe instead of the stock spike.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 72
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Noncommercial
Overview
The stock spike mount on Sonance outdoor satellite speakers (and similar form-factor landscape speakers) leaves the cable entry and threading exposed to the elements — dirt, moisture, and insects all take their toll over time. This adapter eliminates the spike entirely and replaces it with a purpose-fit PVC coupler, allowing the speaker to mate directly with a standard ¾" PVC pipe riser run underground.
The result is a cleaner visual profile in your landscape bed, better cable protection, and a more robust long-term installation.
Design Details
The coupler features a flanged upper seating surface that nests into the speaker's existing bottom boss, maintaining the same articulation range as the original spike assembly. Four internal ribs provide angular registration and structural support against lateral loading. A tapered inner bore transitions to the ¾" PVC pipe OD for a positive, rattle-free fit. The overall silhouette is low-profile and unobtrusive — especially once the speaker is seated.
Designed and modeled with cross-section clearances validated against the original Sonance hardware geometry.
Compatibility
Designed for the Sonance Satellite outdoor landscape speaker
PVC interface sized for Schedule 40 ¾" pipe (nominal OD ~1.050")
A test fit before final installation is still recommended, as print shrinkage varies by material and printer calibration
Printing Recommendations
Material: PETG or ASA strongly preferred for outdoor UV and temperature resistance. PLA is acceptable for shaded installations but will degrade over time.
Infill: 40–50% recommended
Orientation: Print with the flange face-down for best surface quality on the seating surface
Supports: Not required in the recommended orientation
Layer height: 0.2mm standard; 0.15mm if you want a cleaner flange face
Installation Notes
Run your speaker cable through the ¾" PVC riser before seating the coupler. The cable path follows the same route as the original spike. Once the coupler is on the pipe, seat the speaker and adjust aim angle before the coupler fully sets — the fit is intentionally snug to hold position without additional fasteners.