Mermaid Corbels - Repaired
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I loved the look of these Mermaid Corbels (I didn't even know what a "corbel" was before I saw these!) uploaded by…
- Ocena
- 4,6 / 5
- Polubienia
- 141
- Pobrania
- 537
- Wydruki
- 5
- Wyświetlenia
- 2667
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I loved the look of these Mermaid Corbels (I didn't even know what a "corbel" was before I saw these!) uploaded by @darkside501st but when I went to print them, all three threw up errors in Cura, with the left being the worst. The left model was turned completely inside out! I imported these into blender, cleaned them up the best I could, and then let netfabb do the rest. I would have preferred to get these down to a single shell, but ... you have to balance time and effort with results.
For the best quality, print these upside down with supports enabled. I prefer Tree Supports in Cura. They are easier to remove and leave fewer scars.
I wanted to use these on an 8" shelf I put up so I added a stretched version of each that extends the upper ledge by 54.5mm. Then I was able to scale it up in my slicer as large as I could go - about 6-1/2" long. I reckon I'll use either Gorilla Glue or Liquid Nails to attach them.
@tato_713 made a great suggestion... you could use these as bookends, too!
Print Settings
Printer Brand:
TEVO
Printer:
Tarantula
Rafts:
No
Supports:
Yes
Resolution:
0.1mm - 0.2mm
Infill:
20%
Category: Decor