1 / 2
Adapter for STANAG and GOST standards for gas masks (for M10) — zdjęcie 1
1 / 2

Adapter for STANAG and GOST standards for gas masks (for M10)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Adapter between GOST and STANAG standards for gas masks, optimized for the Czech M10 gas mask

Ocena
0 / 5
Polubienia
0
Pobrania
20
Wydruki
0
Wyświetlenia
134
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Masks
Licencja
Creative Commons — Attribution — Noncommercial

Since I didn’t want to use 40-year-old LF10 filters in my M10 gas mask, I decided to make an adapter so I could use newer filters with a valid warranty instead. I opted for the NATO standard—STANAG 4155.

This model is optimized for the M10 mask (and likely for the M10M as well). To print, I recommend using PETG and coating the print with epoxy or superglue after print, to improve the seal. You also can try use FLEX filament for beter tightness but i didnt test it.

The mask may become unbalanced after use and may leak!

When I tested it, it leaked same as before and it wasnt unconfortable but it doesn't always have to be that way. 

In the future, I’m planning a variant where the entire filter will be replaced by just a threaded assembly, allowing the filter to be inserted deeper into the mask.

I consulted with AI regarding the dimensions, but otherwise the model was created entirely by hand.

Tagi