1 / 2
Adapter for STANAG and GOST standards for gas masks (for M10) — image 1
1 / 2

Adapter for STANAG and GOST standards for gas masks (for M10)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Adapter between GOST and STANAG standards for gas masks, optimized for the Czech M10 gas mask

Rating
0 / 5
Likes
0
Downloads
20
Makes
0
Views
134
Reviews
0

Updated at source:

Model information

Category
Masks
License
Creative Commons — Attribution — Noncommercial

Since I didn’t want to use 40-year-old LF10 filters in my M10 gas mask, I decided to make an adapter so I could use newer filters with a valid warranty instead. I opted for the NATO standard—STANAG 4155.

This model is optimized for the M10 mask (and likely for the M10M as well). To print, I recommend using PETG and coating the print with epoxy or superglue after print, to improve the seal. You also can try use FLEX filament for beter tightness but i didnt test it.

The mask may become unbalanced after use and may leak!

When I tested it, it leaked same as before and it wasnt unconfortable but it doesn't always have to be that way. 

In the future, I’m planning a variant where the entire filter will be replaced by just a threaded assembly, allowing the filter to be inserted deeper into the mask.

I consulted with AI regarding the dimensions, but otherwise the model was created entirely by hand.

Tags