SV08 MadMax Dock
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
MadMax dock for dragonburner shroud
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 173
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
MadMax dock for dragonburner shroud. Bracket mounts with the idler mount screws (requires longer screws) if you install the rear screw from the bottom you can place a nut on top to get better clamping of the bracket to the idler. and gets three m3x4x5 heatserts for mounting the dock. Dockplate mounts to the bracket with 3 m3 screws and is slotted for adjustability in the z axis. Bracket leaves access to idler adjuster set screws when dock plate is removed. Use 420mm 2020 extrusion for crossbar, with m5 screws and roll nuts. When mounting crossbar, ensure the docks are true vertical (the crossbar will keep them that way). If using without crossbar, you may need to shim between mount bracket and dock.
Left and right brackets are different, dock can be mirrored for opposite side. I have not tested the docks mid crossbar, but will be doing that soon. Math says you should be able to 5 DragonBurner toolheads with this setup and 6mm buffer between toolhead and adjacent dock. If you are willing to cut that margin to 1mm you could fit 6 DragonBurners. Other toolheads would depend on width.
Edited for V2.
Edited for pics of V2. Four docks installed, only 2 toolheads at time of picture.