1 / 2
Heewing T2 C20T Gimball DJI O4 Pro and Matek Airspeed Sensor — zdjęcie 1
1 / 2

Heewing T2 C20T Gimball DJI O4 Pro and Matek Airspeed Sensor

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Remix of a nose for the Heewing T2, which I added a few compatibilities I needed for my use case!

Ocena
0 / 5
Polubienia
0
Pobrania
20
Wydruki
0
Wyświetlenia
202
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Share Alike

Hi all!
Here is my remix of another design posted here on Thingiverse. Made the mount compatible with the DJI O4 Pro, which bolts on the rear, and a 5V fan bolted on the front. The C20T gimbal sets as previously designed, with an airspeed probe (Matek ASPD-4525) on the top right side. The picture and video posted are both from where I had it previously, and I also fixed the DJI O4 Pro antenna to 45 degrees.

Printed with PLA-LW - 1 wall, gyroid infill. Mounting holes were reinforced with THIN CA

You will have to cut a bit of the front of the nose to allow the pitot tube plumbing to not be kinked, same to allow O4 air unit to fit, and for the DJI O4 antenna. 

Tagi