Side-Release Buckle for Adidas Fannypack.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The male part of the side-releasing buckle for Adidas FannyPack.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 130
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Fashion Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
I designed the male part of a side-release buckle for an Adidas fanny pack. The original prongs on my pack broke, so I created and printed a replacement to keep using the bag.
I printed it in PETG with 100% infill and a 0.20 mm layer height. I also tried printing it at a 45° angle, which worked well. However, for maximum strength, I recommend printing it flat on the bed, as shown in the STL file. I also made the prongs thicker than the original to improve durability.
The tolerances are quite tight, so depending on your printer and settings, you may need to trim or file down the area shown in the image below. My printer didn’t produce edges that were sharp and precise enough, so the clip didn’t lock properly at first. However, two quick cuts with a razor blade were enough to make it fit perfectly.
