Magellan RoadMate Replacement GPS Mounting Base
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The suction cup mount for my Magellan RV9165T-LM RoadMate GPS busted so I was looking for another way to mount it. I…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 123
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The suction cup mount for my Magellan RV9165T-LM RoadMate GPS busted so I was looking for another way to mount it. I decided to model it after the dashmount for an old iQue3600 Palm Pilot / GPS. This is the result. It utilizes the original GPS mount and the attached ball-jointed arm, along with the original toothed inserts.
This is assembled like so:
bolt > mount > washer > insert > arm > insert > washer > mount > nut
Once the nut is tightened the arm is locked in position. You can then either mount the base to the dash with double sided adhesive and/or self tapping screws. I left the screw holes small so that you can drill them out to the size needed if you decide to go that way.
Another Sketchup Model - Debunking the Myth that Sketchup is Useless in 3D Printing
Print Settings
Printer Brand:
TEVO
Printer:
Tarantula
Supports:
No
Resolution:
0.2mm
Infill:
30% grid
Notes:
I recommend printing with 4 walls to allow drilling the screw holes out if necessary. You may also want to go with ABS or PETG since this will be in the hot sun. Me personally, I went with Raptor PLA, but I like to live on the edge....
Category: Other