Bottle Rocket Fireworks Nose Cone
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The other day, browsing the site, I game across this Thing for a fin set for bottle rockets. Try as I might, though, I…
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 173
- Wydruki
- 0
- Wyświetlenia
- 1089
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Vehicles
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The other day, browsing the site, I game across this Thing for a fin set for bottle rockets. Try as I might, though, I could not find a single Thing for a matching nose cone. And any model rocketeer will tell you that rockets need a proper nose cone to cut wind resistance just as much as they need find for stabilization. So... here is my contribution to Independence Day.
After printing the original fin sets, I found that they were 1mm too small to fit my 6mm diameter bottle rockets. The fins were also a little too thin for my taste. I therefore remixed those in to this version.
! Have fun andNever Forget 1776 !
Print Settings
Printer:
Tevo Tarantula
Supports:
No
Resolution:
0.3
Infill:
10%
Notes:
It is recommended that you print multiple pieces at one time to allow for proper cooling. I would suggest printing half a dozen or so of these and another half doze or so of the fin sets at one time. Seven of each at 60mm/sec is calculated to print in about an hour or so, so ....
Category: Vehicles