Bottle Rocket Fireworks Nose Cone
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The other day, browsing the site, I game across this Thing for a fin set for bottle rockets. Try as I might, though, I…
- Rating
- 0 / 5
- Likes
- 12
- Downloads
- 171
- Makes
- 0
- Views
- 1,085
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Vehicles
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The other day, browsing the site, I game across this Thing for a fin set for bottle rockets. Try as I might, though, I could not find a single Thing for a matching nose cone. And any model rocketeer will tell you that rockets need a proper nose cone to cut wind resistance just as much as they need find for stabilization. So... here is my contribution to Independence Day.
After printing the original fin sets, I found that they were 1mm too small to fit my 6mm diameter bottle rockets. The fins were also a little too thin for my taste. I therefore remixed those in to this version.
! Have fun andNever Forget 1776 !
Print Settings
Printer:
Tevo Tarantula
Supports:
No
Resolution:
0.3
Infill:
10%
Notes:
It is recommended that you print multiple pieces at one time to allow for proper cooling. I would suggest printing half a dozen or so of these and another half doze or so of the fin sets at one time. Seven of each at 60mm/sec is calculated to print in about an hour or so, so ....
Category: Vehicles