1 / 7
Wio Tracker L1 Pro N-Connector
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A modified Wio Tracker L1 Pro back with a N-Connector flange.
- Ocena
- 5 / 5
- Polubienia
- 4
- Pobrania
- 23
- Wydruki
- 1
- Wyświetlenia
- 357
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 1) (Komentarze: 1)Remiksy (0)Kolekcje (11)Powiązane
A modified back with a N-Connector flange.
The original front of the Wio Tracker L1 Pro can be re-used. Its only uploaded for convenience.
The threaded inserts for the flange need to be glued in, instead of heat pressed!
The holes are large enough for them to be pressed in tight with a tiny bit of glue. This is because the outer wall thickness is thin and would deform with heat.
You will need:
N-Connector Flange 7.5cm (RF-1 F113)