Pick-Rocket 2 (Xshot Menace) Little Rocket Barrel Lug

I updated the old fixed mega Barrel from my old design and replaced it with something more modular. 

1x 16mm oring needed or something symilar in size. The Air Restrictor needs to be removed. And use some teflon or E-tape to make a seal between the plunger and frontplate.

Even though the Xshot menace does have a limited plunger tube, there were posibilities. 
It fired:  Mega arround 55fps, and 3 shot elites/halfdarts with limited range, good enough as a panic button. The sniper barrel performed great with half darts, full-length was not usable. the 1x3 dart Inline clip was decent and very usable, just dont expect it to fire a Demolisher rocket or a big volume shotgun shell. 

I was testing with used darts, those were not so tight on the barrels. I just don't have other ammo available than xshot full-length, halfdart, mega, and demolisher missile as ammo to test with. 

With the original Micro I haven't tested the frontplate yet, but probably should fit just fine (It's plunger tube is just a little bit on the tiny side). After recieving feedback there was noticed that the original micro version1 frontplate did not line up, with the frontplate from this remix, as it has different alignment for the screw holes. I added a Prototype frontplate for this, if i get my hands on another xshot micro, I shall test it too. 

The xshot micro 2.0 is still a mystery for me, to my knowledge the plungertube differs quite a bit as it is wider in diameter but shorter in length. (I tried to put a menace plunger in in a micro 2.0 design but it didn't fit, just check my makes if your curious for proof.)

Might be done a bit roughly, but the proof of concept worked surprisingly well. So I give it back to the community.