Motorola Moto G Power 2021 Phone Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A case for the Motorola Moto G Power, 2021 version. Printed in PLA. PETG would probably work fine as well.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 95
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A case for the Motorola Moto G Power, 2021 version. Printed in PLA. PETG would probably work fine as well. I've printed this number of times and I'm pretty happy with it.
File: MotoGPower2021Case_.stl
I added a design for flexible filaments. I've only printed one prototype of this (in TPU). It seems pretty good, however that was not the final design posted here. (I tweaked it a fair bit since, but I'm low on TPU so just posting for now). I'd highly recommend against printing this in PLA, as it's difficult/impossible to get the phone in/out of the case. In any case, I'm less confident in the fit of this design, so if you have success with the TPU STL, let me know and post-up a Make. Thanks!
File: MotoGPower2021CaseTPU.stl
Notes:
Lay it on it's back to print. No support needed. It bridges the opening for the headphone jack without a problem. Takes about 3 hours to print at 60 mm/sec.
(For the TPU version, you might want support at the cutouts, although it seemed to bridge OK on the prototype.)
Category: Mobile Phone