Subaru Legacy BL/BP HKS SQV 4 Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adapter to turn this VTA BOV into a full Recirculation BOV
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 71
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Share Alike
I got this HKS BOV second hand and it didn't come with the recirculation hose, I did some googling and found out the hose that I was missing wasn't even going to fit my vehicle as this was off of a 2018 Subaru STI(I have a 2005 Subaru legacy). With my vehicle having a MAF sensor, you can't have 100% VTA BOV, so I decided to make my own adapter to see if this would even work, or if I would have a vacuum leak that would end up still stalling the car.
I bought the flange for my car and swapped the HKS BOV over, then I proceeded to trial and error. Eventually I got it to work, no vacuum leaks, and runs perfectly, it is now a fully functioning 100% Recirculation BOV. I designed it to be a very snug fit with no play once installed (literally no play) to ensure a tight seal against the gasket.
Installation.
There are a total of 8 screws on the front of the HKS BOV, you need to undo the 4 protruding(closer to the surface) screws to take off the fin cover and get access to the plastic chrome divider.
take out the plastic chrome tri-fin and install your new 3D printed adapter, ensure the larger tab is on the bottom and the thinner tab on the top, it should be a very snug fit.
reinstall the same 4 screws to put the fin back on.
install in engine bay and you're done!
The good:
Fully functional with no leaks
Has to be made in ABS, ASA, or PA-6 CF to handle engine bay temps and constant stress from the hose clamp.
Easy print in under 1 hour with 3MF settings
Good alternative if you want to switch your car back to full recirculation like OEM.
No modifications required to the rest of the engine bay.
The bad:
you loose the cool “PShhhhh” sound that a BOV normally makes or you don't get the iconic HKS BOV sound. :(