IP2368 PD 100W bi-directional module panel mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Panel mount for IP2368 100w bidirectional buck-boost module
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 104
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
Panel mount for IP2368 100w bidirectional buck-boost module. I've created this with enough space to install heat-sink on bottom of the board.
Even with heat-sink, the module get very hot when I set it to 60w so for higher wattage active cooling is needed.
The design was a bit tricky because the board didn't have any mount point or screw holes, but this worked for me.
There are 4 models included:
Bottom cradle
Top cradle
Outer panel for presentation
Cutout template to help draw lines on the panel you need to cut
To install the board on the cradle you'll need 2 zip-ties, and for mounting to your panel you'll need 2 M3x8 or longer machine screw with 2 M3 nuts.