1 / 1
mBot NEO Top Hat — zdjęcie 1

mBot NEO Top Hat

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Simple Top Hat for the mBot NEO.

Ocena
5 / 5
Polubienia
4
Pobrania
112
Wydruki
0
Wyświetlenia
786
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Three pieces required as couldn't get supports to work.  Simply glue the pieces together to complete.   Fit's mBot NEO pattern on top of controller.  

I printed the top hat topper with 50% infill and that was overkill. 20% would work much better. So time and material estimates are again overkill.  

Top Hat connector pattern and diameter for the mBot is a little undersized at 0.17" dia.  Should be 0.18" dia.  My mBot interface holes are inconsistent at 0.19" to 0.20" diameter and my printer is dimensionally off by +0.007" at this size.  So scale or adjust as needed.

 

Tagi