Bauer (Harbor Freight) Battery Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Battery holders for Harbor Freight's Bauer line of tools
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 59
- Wydruki
- 0
- Wyświetlenia
- 146
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Garage
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I designed these battery holders for Harbor Freight's Bauer line of tools, with the idea that the batteries lock into place, thereby allowing you to mount them upright and slide the battery in from below. This way you can see the power level indicator, as seen in the pictures. Can also mount them horizontally so that you insert the battery from the back, again allowing you to easily check the power level
There are 2 styles. One use 2 #8 wood screws for mounting. The other is designed for use with MultiBoard using 2 T-Bolts to mount, found here: https://thangs.com/designer/MultiBuild/3d-model/9%20mm%20Small%20Thread%2C%20Plain%20Head%2C%20T-Bolt-974363
Printed with PLA, 0.4mm nozzle, 0.2mm layer height, 3 walls, 6 top/bottom layers, 10-20% infill. If printed flat, be sure to use supports, with "only on build plate" NOT selected. If printed on it's end, supports are not needed
06/04/26 - Added a V2 that relaxes the tolerances a little bit to make inserting and removing the battery a little easier