Uplift Desk grommet (80mm) with cable management
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a grommet for the Uplift Desk (80mm) with cable management clips built-in.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 37
- Wydruki
- 0
- Wyświetlenia
- 163
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution
I got tired of the factory grommets that came in my Uplift Desk -- the common variety where you rotate a piece inside to "clamp" the cables. The problem with the original design is that it does not hold the cables securely, and the inner part is prone to getting out of place, which is annoying.
I took me a couple hours to design and print this model. Just remove your original grommet and insert this part. Please note that this part fits in the hole much more tightly than the original, which was one of my goals. If you think it's too tight, scale the model to 99% or so in all dimensions.
Use the space between the circles to hold your cable (as in the picture). This is not subject to stress so you can print it with any filament you like. Make sure the side with the circles is pointing down; use the "Auto Orient" function of your slicer to set the optimal position. No supports or brims needed.
Hit the like button if you find this useful.
Have fun!