Thermomix TM7 display protection bumper and cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
These are a bumper and a cover for the display of Thermomix TM7.
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 63
- Wydruki
- 1
- Wyświetlenia
- 298
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial
As the Thermomix TM7 is an expensive product, I want to protect the display while using it, just like a smartphone display. Thus the bumper stays always on. For my final cover I used the Bumpmesh tool by @CNCKitchen https://www.printables.com/model/1666241-bumpmeshcom-stl-texturizer, but the print file you getting here is the clean version.
The bumper I prefered to print with a brim so the rounded edges stayed in shape. I added a splitted version of a bumper fitting smaller print beds. The bumper has a top side without the two small tabs on the long inner side. The other tabs around the inner corners are securing the bumper slightly onto the display. On the top side of the display with the large led there is no notch under the display. I also printed with auto support setting for these tabs.
The cover is a bit undersized, because I prefer a not so tight fit inside the bumper. It's just laying on top of the display.
I printed both parts in PLA+ with 0.4 mm Nozzle and 0.2 mm layer height (brim and auto support for the bumper).
