Drill Adapter for Manba Ice Shaver
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Drill Adapter for Manba Ice Shaver - Turn your Manba Ice Shaver into a motorized ice shaver!
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 412
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Share Alike
With this drill adapter, ice shaving can be way more fun and way faster!
This model is printed with the handle side down with aggressive settings for part strength. The slight taper should help keep the drill centered on the handle.
I would suggest using the following to get a stronger print:
- .2mm layers or thinner for better layer adhesion and less gaps
- Lower fan speeds than normal for non-bridging parts to increase layer adhesion
- Higher fan speeds than normal for bridging
- I used 5 perimeters on my print in order to make the bottom part 100% printed out of perimters rather than infill
- 100% infill
I tried this with PLA+ and PETG. I was able to get this print to work well for me with both, but my first PLA+ print only lasted two weeks of nightly use before breaking. I beefed up the part a bit since then.
Please beware of the swinging handle when using the drill adapter! The handle will swing around wildly. You may end up breaking your ice shaver, so please print and use at your own risk. Because of this, I use this adapter on the slower drill setting. This worked for my own ice shaver, but I can't guarantee that your ice shaver will work well with this adapter.