Magnetic Keyboard Thigh Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This mount allows you to sit or stand while keeping a keyboard perfectly positioned under your hands.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 135
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
This is a thigh mount that was created to pair with the Svalboard keyboard. It is comprised of two parts, the mount and the shuttle, which allows the svalboard to slide to the best position. When seated the sval slides to the bottom of the mount and is held in place by a heatset insert. When standing the magnets hold the shuttle at the top of the mount.
There are 2 pairs of 30x2mm magnets in each mount (eight magnets in total).
Parts Needed:
Magnets - 30mm, I used multiple 30x2mm a that is what I had on hand. using One 30x4mm magnet in each slot would likely work just as well. https://www.amazon.com/dp/B0CBS9B4JQ?th=1
Heatset insert - used as a catch/stop for the shuttle. The smooth section opposite the threads is left sticking out the bottom of the shuttle. Doesn't have to be these exactly, just so long as the exposed portion is no bigger 4.35mm: https://www.amazon.com/dp/B0CDH36ZMX?th=1
Nylon strap - 6 yards of 1 Inch strap: https://www.amazon.com/dp/B08LD8CJ8D?th=1
Build instructions:
Suggest 3 walls and 15%
Heat sets go in the small holes and are inserted from the side with the lettering embossed into it. The bottom end of the heatset MUST extend through past the face of the shuttle to function as a stop.
Magnets should be inserted such that the shuttle and mount attract and hold the shuttle in place.
Straps and buckles should be cut and fused to the necessary length for your thigh length.