LayersFactory
Zgłoś model
1 / 3
pendrive case — zdjęcie 1
1 / 3

pendrive case

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Share Alike
SzczegółyWydruki i komentarzeRemiksyKolekcjePowiązane

The Problem Stripped flash drives and raw USB connector boards are fragile and can be difficult to plug in and unplug safely without bending the board or touching the exposed contacts.

The Solution I designed this simple, low-profile sleeve to slide snugly over the back end of the PCB.

Features

  • Friction Fit: Designed to hold onto the board securely. (Depending on the exact dimensions of your specific USB board, a tiny drop of CA glue can be used for a permanent hold).

  • Better Grip: Adds just enough thickness to make inserting and removing the device much easier.

  • Rapid Print: Takes only a few minutes to print and is a great way to use up the very last bits of filament on a spool.

Print Settings

Because this part is so small, precision settings are highly recommended.

  • Layer Height: 0.12 mm (Crucial for getting an accurate internal tolerance so it fits the PCB snugly).

  • Infill: 100% (Given how thin the walls are, your slicer will likely print this entirely out of perimeters anyway).

  • Wall/Perimeter Count: 3 walls.

  • Orientation: Print standing vertically (with the opening facing up) for the best results.

  • Supports: No supports required.

Tagi

diyfixpendriveusbstick