Sovol SV08 Build Plate Aligner with Wire Brush Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Use this to align your build plate more effectively I only use one on the left side near top left of bed (see image)
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 100
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Remixed this awesome model by Valerie Moore which helped me get my build plate aligned on my sv08.
https://www.printables.com/model/1111031-sv08-build-plate-alignment
Upgraded it a bit by adding a holder for a brass brush to help with coprint filament changes for wipes.
Works better than the current system of just wiping across the build plate for a couple reasons.
better wipe across full nozzle so less likelihood of residual filament staying stuck on
doesn't damage nozzle tip as much because its not grinding across bed
makes sure filament blobs don't get lodged in your prime tower leading to purging failures later on or your prime tower being ripped from bed
In my opinion better than the silicone brush on the top right of sovol build plate because of more coverage the silicone one holds on better to blobs and they sometime get stuck on the next wipe go around
Yes all these issues are from experience it took a lot of failures so hope this helps someone. Just buy the
The part should snap over the piece easily print in same orientation with supports to help with overhanging part.
I used some basic brass brushes like these below
I snapped them pretty close to the start of the handle with my hands which was pretty easy but be careful of the bristles they can and will dig into your skin if you push too hard against them so use gloves or a towel to be safe (Yes also figured out from experience). The holder is about 40mm in length which should hold the brush end fine I also used some double sided tape to hold down the brush for a bit more stability.
Let me know if you make it and if you can think of improvements, may continue to update this if I find any worthwhile upgrades to make