Gastronorm Mounts for Chopping Board 1/3, 1/6, 1/9
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A box to hold Gastronorm trays next to a chopping board to aid with mise en place or waste disposal.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 196
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A box to hold 65mm 1/3, 1/6, 1/9 Gastronorm trays to the side of a chopping board to aid with mise en place or waste disposal.
For each set of L and R you will need either,
3 screw connectors are needed along with 6 M5x10mm screws to hold them together.
3 glue connectors and some glue.
The no split version does not need connectors, but will need a print bed of 335x285mm minimum.
To have on one side of a chopping board only, you will need two of the board supports
There are small indents on the bottom and chopping board shelf/supports for 10mm rubber foot pads.
My chopping board is around 57mm deep so this is sized for that. For a shorter board, you will need to adjust the board shelf to be higher to keep the ability to wipe off into the trays. Alternatively, you could re-size up or down for a different depth tray.