CRKD Neo S Magsafe Phone Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A detachable MagSafe mount that makes the CRKD Neo S a compact and travel-friendly controller for your phone.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 118
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
CRKD Neo S Magsafe Phone Mount - Your Everyday Companion.
I’ve been searching for the ideal mobile controller setup for a while—something portable, with full travel triggers and a standard layout. That combination is surprisingly hard to find.
The closest match was the 8BitDo SN30 Pro Xbox Edition, but then I discovered the CRKD Neo S. While it’s not as compact, it feels and performs like a full-sized controller. The official Mechanism mount, however, didn’t quite meet my expectations—so I designed this MagSafe mount as an alternative.
1. Overview
Modified ‘Mechanism’ mount:
This design is based on a 99% scaled version of the universal mount from Mechanism (available on their website), with increased strength, tighter fit and higher positioning.
Even without the MagSafe attachment, the controller sits higher to prevent your grips from getting scratched when placing it down.
Note: This version is not compatible with the CRKD x Mechanism mount due to strength and ergonomic concerns.
Magsafe mount
The mount features 43mm inner and 55mm outer diameter. This allows you to install your own MagSafe ring, magnets, or even repurpose components from an old MagSafe charger (as shown in the photos - don;t use the charger housing like I did at the beginning). Cheap Aliexpress rings aren't enough to hold a phone in place. The mount itself can be positioned both downward (like mine), or upward, depending on your preference.
Functionality:
This mount makes it easy to adapt the angle for your needs. When redundant, it's easy to take it off and fold.
While you can’t charge the controller with the mount attached, it remains useful as a standalone phone holder.
It handles phones with ease and even supported a 13" tablet as in the photos. After ~1 month of use, one screw tightening was needed.
2. Additional parts:
Apart from the included models, you also need:
4 × M3 screws (max length: 20 mm)
Strong double-sided tape (e.g., Scley 774)
MagSafe ring or magnets
Assembly tip:
Attach both mount parts together first, align the protrusions with the slots on the controller, then secure the controller mount in place (right above the “prog” button).
3. Print settings:
Material: PETG
Layer height: 0.16mm
Infill: 45%
Supports: Tree supports enabled
Wall loops: 3
