1 / 9
GEPRC Mark 5 / Phisital Mark 5 — JHE42B Buzzer Holder with Coaxial Cable Protection — zdjęcie 1
1 / 9

GEPRC Mark 5 / Phisital Mark 5 — JHE42B Buzzer Holder with Coaxial Cable Protection

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a refined buzzer holder for GEPRC Mark 5 and Phisital Mark 5 frames, specifically designed for the JHE42B buzzer

Ocena
0 / 5
Polubienia
1
Pobrania
26
Wydruki
0
Wyświetlenia
112
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Share Alike

English:

This is a refined buzzer holder for GEPRC Mark 5 and Phisital Mark 5 frames, specifically designed for the JHE42B buzzer.

Key Improvement: The main feature of this model is the top safety bridge. It serves two critical purposes:

  1. Cable Protection: It prevents the buzzer from touching or damaging the sensitive camera coaxial cable located directly above it.

  2. Double Security: Even in high-G impacts, the buzzer stays locked in place, ensuring it never shifts towards the internal electronics.

Field Tested: Reliability confirmed! The mount has survived multiple hard crashes and tumbles. The buzzer stayed secure, and more importantly, the camera cable remained perfectly safe and untouched.

Russian:

Доработанный холдер буззера для рам GEPRC Mark 5 и Phisital Mark 5, спроектированный под JHE42B.

Основное улучшение: Главная фишка этой модели — верхняя защитная перемычка (ограничитель). Она решает две важные задачи:

  1. Защита шлейфа: Ограничитель не дает буззеру при ударах контактировать с коаксиальным кабелем камеры, который проходит прямо над ним.

  2. Двойная фиксация: Буззер заблокирован сверху, что исключает любые смещения в сторону электроники при жестких падениях.

Проверено в деле: Надежность подтверждена тестами. После краша и «кувырков» буззер остался на месте, а коаксиальный кабель — в полной сохранности.


Print Settings
  • Material: TPU (95A).

  • Infill: 100%.

  • Supports: Yes (minimal for the top bridge).

Follow the project:

Tagi