XT60 Housing - Remix
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix (slotted only) with the same external dimentions. Two parts to be connected using M3 x 8mm screw & nut…
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 91
- Wydruki
- 0
- Wyświetlenia
- 234
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
Remix (slotted only) with the same external dimentions. Parts to be connected using M3 x 8mm screw (M3 x 10 is too long) and M3 hex nut.
I do not know if XT60 connectors I have at home are genuine or not and what are the differences between them %-) However, they fit into original connector (that I remixed from) with minor issues (too hard to put wire and a small gap between parts as not enough width). So I believe if you can use original model, my model will work for you as well.
Added "stop" that holds connector in place (no need to glue it);
External grips;
Hex hole for nut;
Additional inset for better positioning;
More room for cables;
Top/bottom walls' width extended from 0.7mm to 0.8mm (that is better for printing with 0.2mm layer height);
XT60 connector's room extended from 8.04 to 8.2mm (XT60 width by spec 8mm);
STEP file published.
Should be printed "grip sides on table" without supports using layer height 0.2mm and line width 0.43-0.5mm.
May the electric power be with you.