XT60 Housing - Remix
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remix (slotted only) with the same external dimentions. Two parts to be connected using M3 x 8mm screw & nut…
- Rating
- 0 / 5
- Likes
- 12
- Downloads
- 91
- Makes
- 0
- Views
- 234
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
Remix (slotted only) with the same external dimentions. Parts to be connected using M3 x 8mm screw (M3 x 10 is too long) and M3 hex nut.
I do not know if XT60 connectors I have at home are genuine or not and what are the differences between them %-) However, they fit into original connector (that I remixed from) with minor issues (too hard to put wire and a small gap between parts as not enough width). So I believe if you can use original model, my model will work for you as well.
Added "stop" that holds connector in place (no need to glue it);
External grips;
Hex hole for nut;
Additional inset for better positioning;
More room for cables;
Top/bottom walls' width extended from 0.7mm to 0.8mm (that is better for printing with 0.2mm layer height);
XT60 connector's room extended from 8.04 to 8.2mm (XT60 width by spec 8mm);
STEP file published.
Should be printed "grip sides on table" without supports using layer height 0.2mm and line width 0.43-0.5mm.
May the electric power be with you.