1 / 9
Bracket for Athom Power Monitoring Mini Relay for ESPHome — zdjęcie 1
1 / 9

Bracket for Athom Power Monitoring Mini Relay for ESPHome

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I had to install the mini relay somehow to the wooden shelf

Ocena
0 / 5
Polubienia
6
Pobrania
19
Wydruki
0
Wyświetlenia
82
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

About
I needed to install Athom Power Monitoring Mini Relay for ESPHome, so I quickly designed one.

This was designed to be screwed into the wood plank, the distance between the external holes fits into a grid 20x20mm lines, holes for 4mm screws with a flat heads.

If you have other ideas then leave a commend and I can add another mounting option.

Please give likes, review and suggestions for improvements. Also make sure to do the same to the original authors of the models used. Thanks!

Changelog:

  • 2026.05.05 - initial release

Print

  • provided gcode is just for time and material estimations

  • print in the orientation as the models are seen on the photos

  • 0.2mm layer height  0.4mm nozzle, STRUCTURAL profile recommended

  • use supports, snug recommended, and they should be easily removable

  • no brim, no skirt

  • 20% infill, 2 perimeters or more

  • recommended PETG because it is more elastic and makes it easier bend the clamps and later to disassemble it

Assembly

  • Use screws to mount the bracket to the wall or shelf, 4mm in diameter with flat heads recommended.

  • Gently move the clamps to the sides (you can use a thin technical knife for it) and slide in the relay, keeping the button up as on the images

Tagi