1 / 18
Ducato Camping car side screens plissee (pleated) blinds — zdjęcie 1
1 / 18

Ducato Camping car side screens plissee (pleated) blinds

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Cost effective and easy to handle cabin side windows blinds for our Ducato camping car (RV)

Ocena
0 / 5
Polubienia
7
Pobrania
13
Wydruki
0
Wyświetlenia
557
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

There is very little 3D printing involved. I used plastic strips from a construction market.

I ordered the blinds from China.

Parts needed:
There is very little 3D printing involved. I used plastic strips from a construction market.
I ordered the blinds from China. There are many options. You can even have two colors (alu reflecting outside and black inside).
Few bolts and nuts (M5)
Contact cement (glue)
6x magnets, 20x3.5mm, with a hole in the middle for the rear side of the window
Optionally 4x magnets, 20x2, with a hole for the front side of the window. (see How to: no holes in door)
4x magnets, 20x2 mm, no hole in the middle for the lower front side of the window for a better fit
A large piece of paper for the template
Plastic strip as used in the kitchen, 30mm wide and 2mm thick. You need to cut two pieces 46 cm long.

Printing:
Filament: PETG (PLA will melt, as it can get very hot in a car)
2x P1.stl (I know... you could use the same kitchen strip, but then I could not place this how-to here.)
Optionally 2x P2.stl for storage.

How to:
First do the 3D printing. No support ;-)
Once "all the printing" is finished, cut the plastic strips. Cut the length to 46 cm and drill the holes.
Place the magnets (for now, protect the magnets with tape in order to protect the door's paint).
Check the fit on the door.
Create a template using paper. A good method is to use many papers stuck to the correct shape using tape.
Basically the same method as used by carpenters.
Check and double-check the template.
Start cutting the plisse (keep it VERY wide in the corner of the front area). It is better to cut twice than order a new palace.
Glue the palette to the strip using double-sided tape for now to see if the size is correct.
Once you are happy, glue the strip and the curtain with glue. The core should be between the door and the magnets (remove the tape).
Check the fit once again.
Our Ducato had holes in the door for the original palisade. Replace the push-button seats with the magnets using screws.
If you have no holes, simply skip this step. The magnets in the palace will hold on the metal door near the hinge.

When happy with it, place the magnets in place, mark the place with a pen, and mark the magnets in the right POLARIZATION.

Now glue the magnets in place. BE SURE TO CHECK THAT THE POLARIZATION IS OK, as the magnets with a hole fit only one way!

That is all.

Oh, one more thing. You might like also this:
https://www.printables.com/model/1430123-ducato-camping-car-front-screen-plissee-pleated-bl

Enjoy,

s10k

Tagi