0.25-20_Ball_and_Socket_CameraMount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Camera mount option for the Ball and Socket remix from @ORDEEP.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 48
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution
Instead of the 2020 Extrusion mount in the remix by @ORDEEP, I substituted a 02.5-20 threaded stud, like those used on camera mounts. This allowed me to then mount a Raspberry Pi Zero 2W (mounted in the Raspberry Pi Zero W Case w/Camera on Thingiverse) in my IKEA Lack Enclosure.
I had to crank down pretty hard on the knob to get the Pi to stay in place, but that's not too surprising given that it's holding the Pi in a horizontal position. A little tweaking of the nut size might make it easier, but I haven't tried that yet since it's working as is.
Printed in Overture PETG, 2.0mm STRUCTURAL, 15% fill.