1 / 6
TPU Feet for CoreOne Feet by @prusaguy — zdjęcie 1
1 / 6

TPU Feet for CoreOne Feet by @prusaguy

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This TPU foot fits perfectly in the Prusa Core One Feet v1 by @Prusaguy

Ocena
5 / 5
Polubienia
13
Pobrania
25
Wydruki
1
Wyświetlenia
317
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Summary:

  • The feet are designed to slide into the bottom of the legs designed by @prusguy. 

  • No glue or hardware needed

Tips:

  • TPU can be finicky, and settings vary between brands, but don't be discouraged. It's more approachable than it seems!

  • The default Prusa slicer settings for TPU performed well and are a solid starting point.

  • Note: High flow nozzles may cause feeding issues due to filament flow splitting. It is recommended to use a standard nozzle for sizes under 0.6mm. Testing with a 0.4mm HF nozzle is ongoing and results will be posted when available.

  • The standard filament path was used; however, some back-and-forth manipulation was needed to properly seat the filament into the sensor/feeder. It is worth noting that bypassing the standard filament path is a common practice to reduce friction during feeding.

Settings Used:

  • Material: TPU

  • HF Nozzle: 0.6mm @ 235°C

  • Bed: Satin @ 55°C

  • Layer Height: 0.2mm

  • Chamber Temp: 40°C (A wide range has been reported in the community; TPU has also been printed successfully on an open-frame MK3.)

  • Infill: 20% Grid

  • Max Volumetric Flow: 0.6mm HF Nozzle = 12mm³/s | Standard Nozzle = 3-4mm³/s (Useful reference if custom settings are required.)

  • Brim: 5mm

Leg Installation Tips (for @prusaguy's legs):

  • Short wood screws are recommended over M3 screws for assembly. Ensure the screws are short enough and have a thread diameter that fits through the holes on the underside of the CoreOne frame.

  • Use a box or socket wrench with a small screw bit to drive the screws through the frame holes and into the top of the legs. A short bit from a standard tool kit works well for this.

Products:

Disclaimer:

  • Links may take you to Amazon or Prusa.com for products I endorse and use on a regular basis.

  • JD3D is not responsible for any damage or harm caused by improper production, assembly and use.

Tagi