1 / 9
KIA AddGear to IKEA Skadis connector — zdjęcie 1
1 / 9

KIA AddGear to IKEA Skadis connector

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

These components can be used to connect an IKEA Skadis pegboard to the KIA AddGear system (e.g. in the trunk of the PV5)

Ocena
0 / 5
Polubienia
4
Pobrania
39
Wydruki
0
Wyświetlenia
517
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

These components allow a standard IKEA Skadis pegboard (https://www.ikea.com/de/de/p/skadis-lochplatte-schwarz-80534372/#content) to be attached to the KIA AddGear system.

There are two types: a hook into which the Skadis board can simply be hooked, and a kind of latch that is engaged by turning the AddGear anchor so that the board cannot slide forwards. The distance between the AddGear anchor and the hook or latch corresponds to the distance of the spacers supplied with Skadis.

As you can see in the photos, I cut a black 36x56 cm perforated panel down to 36x39 cm (using a circular saw – it’s wood) so that it doesn’t protrude into the window. I then fitted two hooks, one at the top and one at the bottom, into the first AddGear slot, and then secured the panel with two bolts (top and bottom) into the fifth AddGear slot. Skadi’s holes are spaced 4 cm apart and the AddGear slots (PV5 at the rear) are spaced 7 cm apart; accordingly, the centre-to-centre distance is 28 cm, which fits very well.

Of course, there are bound to be other combinations (including with the 56x56 plate, etc.), but everyone can try those out for themselves.

Now, of course, the question is: why would you do something like this? For example, in combination with the matching expanders (https://www.ikea.com/de/de/p/skadis-elastikband-grau-40321631/#content), you can create a great attachment for protective vests, first-aid kits, shopping bags, etc. And, of course, you can now theoretically attach any Skadi accessory, and as we all know, there are loads of 3D printing templates available. However, you do need to bear in mind how much weight the components can bear; I have no experience with this and naturally offer no guarantee whatsoever. It will certainly depend on the material they are printed from; I used ASA here I have set the perimeter (wall thickness) to a very high value of 7. The anchor is based on the Orginal AddGear file from Kiahttps://www.kia.com/kr/customer-service/kia-members/kia-addgear/development-ecosystem 

Tagi