1 / 7
Unifi UTR Thermal Spacer Plate (v3) — zdjęcie 1
1 / 7

Unifi UTR Thermal Spacer Plate (v3)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Reduces temperature between the UTR & another surface or device. Wider profiled cuts, 3mm air gap & band guides (v3)

Ocena
5 / 5
Polubienia
2
Pobrania
48
Wydruki
1
Wyświetlenia
735
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

This is v3 of the model, Ultimate Edition.
EVEN more ventilation ability but supports are required.

  • Elevates UTR device by 3 mm to improve passive airflow and reduce heat build-up

  • Ventilated underside design promotes air circulation (improved over v1)

  • Helps maintain lower operating temperatures during sustained use

  • Designed for use between travel routers / compact networking gear and power banks

  • Lightweight, low-profile form factor adds cooling without bulk

  • Precision-fit footprint for stable placement and reduced wobble

  • Ideal for portable setups, travel rigs, and always-on devices

  • Optimized for 3D printing with common materials (PLA, PETG, etc.)

  • Simple, durable design with no assembly required, supports are required!

Powerbank in photos is UGREEN Nexode Qi2 10,000mah, PB763 is the model number.

v3 (this model) & v2: The temperature readings I get on the UTR is 40.2°C on the screen. 41.1°C hottest spot on top, and 42.6°C max on the bottom when using the model.

v1: The temperature readings I get on the UTR is 42°C on the screen. 42.4°C hottest spot on top, and 45.6°C max on the bottom when using the model.

PETG would be ideal as temperatures are too close to 50-60°C for PLA usage, but still possible.

Need one profiled for the top surface of a UGREEN Magnetic Wireless Power Bank PB763, as seen in the photos? Check out v3.1 here:


Tagi