2.5" Vice Jaw Pads - Dimensions Fixed and Magnets Changed
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Changed the dimensions to accommodate 2.5" jaws and increased depth and bottom ridge to fit a Harbor Freight table vise
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 1
- Wyświetlenia
- 17
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a modified model to truly fit a 2.5" wide vise jaw and increased in size to handle jaws 22mm high and other geometry to fit my clamp on Harbor Freight 2.5" spinning table vise.
The original model was built to fit 58mm wide and 12.8mm tall vise jaws which is about 2.28x.74" though advertised as 2.5". I really liked the design, just needed it to fit a real 2.5" jaw and wanted to use magnets I had on hand I've found are more common in other models - just my opinion.
Printed in Elegoo ASA, 4 walls, 3 top and bottom surfaces, 20% gyroid infill, and seem very sturdy. There's a little bit of tolerance (1mm) on the width to allow for printing variances. You can easily modify it, I did in TinkerCad, as it's a very straight forward shape. The picture is a prototype in Kingroon PETG to check fitment after the dimensions were adjusted.
