Venty Silicone Attachment Stabilizer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I always found it very annoying how unstable the silicone Stems attachments for the Venty were, so i decided to…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 102
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I always found it very annoying how unstable the silicone Stems attachments for the Venty were, so i decided to improve them. The process is a bit scuffed but works. You need to print the Part, then you can insert the Silicone Attachment from the Venty inside. The Attachment Stabilizer basically bypasses the silicone mounting mechanism without exposing any PLA to the Heatstream. You need to cut away 3mm (the attachment ring on the silicone attachment) so test the print if it fits on your venty before cutting away. I hope this helps you. Be careful when cutting the bottom part of the silicone to not damage the inner silicone ring.
Category: Other