Fanatec CSL Shake-It rumbler
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Designed for "CSL Pedals Tuning Kit"
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 37
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Rumbler for the Fanatec CSL Pedals Tuning Kit.
Can be combined with my "Arduino Uno Adafruit Motorshield case" to build up a whole working system.
Partlist
For mounting the rumbler unit to the pedal, the pedal's screw and nut is to be used.
Amount | Part | Info |
|---|---|---|
1 | FanatecCSL_Rumbler | To be printed lying on the side. PETG filament or similar recommented, that has similar mechanical ability. |
2 | FanatecCSL_Rumbler_Motorcap | To be printed. PETG filament or similar recommented, that has similar mechanical abilit. |
1 | M4 self locking nut | |
1 | M4x15 hexagon socket head screw | |
2 | Small Zip Tie | Max width of 6mm |
1 | R-370 DC vibration motor | https://www.amazon.de/dp/B0B1JGPS3X?ref=ppx_yo2ov_dt_b_fed_asin_title Type R-370; 2 Oscilators; Oscillating head diameter: 24 mm (0.94“); Motor housing length: 30 mm (1.18”); Motor housing diameter: 24 mm (0.94"); (12 V DC; Speed: 8,500 RPM) |
Assembly
Allign the M4 nut for the clamp of the FanatecCSL_Rumbler_Motorcap into the hole for the nut and mount the M4 screw from the other side and keep it loose. A long screw can help to place the nut as shown in the following picture:
Solder the cable to the soldering pins of the DC motor.
Place one of the FanatecCSL_Rumbler_Motorcap over the DC motor. Align the slot so that the cable can pass through. The Motorcap has a lid on the inside which must be aligned with the oscilating head, so that the lid can reach the motorhousing and the cap sits properly.
Position the premounted unit into the FanatecCSL_Rumbler with the cable on the side were the holes for the zip ties are.
Slide from the other side the second FanatecCSL_Rumbler_Motorcap. Align the slots with each other and turn them into a direction so that it points to the direction of the next zip tie position.
Make sure the whole unit is centered and then tigthen it.
Secure the cable by using the zip ties.
Apply the nuts of the pedals in the FanatecCSL_Rumbler and mount the unit to the pedal.
Secure the cable on the side of the metal sheets of the pedals. Make sure that it cannot be cut by the movement of the pedal and give it enough space so that it is not stretched.
Example:
If you have any comments, suggestions or similar, you are welcome to contact me.