Aukey Magsafe Charger Car Adapter

One night i could not sleep and came across Peltier cooled Magsafe chargers. My phone was lagging like hell after being charged and giving directions on a long card drive. iPhone 15 Pro Max

So i thought i would give it a try. The  Aukey Magfusion charger was on sale at Euronics at the time. I ordered it. The Aukey Magsafe charger was designed to keep your phone cool, while you are gaming, but i don't do that.

There is a seperate car charger from Aukey, but it hooks into the air vent, which i do not like! I have already broken one vent with cheap Magsafe charger...

I already have a Spigen Magsafe Charger installed, been working fine for the past 2 years.

I designed this adapter to fit specifically for the Spigen Magsafe Car Charger Ball Joint. However the files are there, feel free to modify to fit your need. 

I made a sketch of the Magsafe Charger itself, if you want to give it a go.

It cools the surface down to 1C, if you have a phone installed 10C. According to Youtube video it charges faster than via cable, because of the active cooling. I did not  test that.

Here is the OnShape File, it is kind of a mass, i am a self-taught 3D designer. This is my most complex design yet.

https://cad.onshape.com/documents/6873f4975ff465a8a8e8d122/w/f0e0aabe7f0d2885bd88b24f/e/111e7ec502525753d90db837?renderM

Used Hardware:

M3 Bolt M3x16 should be fine

M3 Heat Set Insert the spiral one(see photo). OD: measured 4.97mm Length: 6mm (from Aliexpress  long time ago)

After the fact it would have been easier just design a whole lever arm (see last two picture) instead of the ball joint. The ball joint was hard, i found an already working design and cut it apart in Prusaslicer. Merged it to my Base. Removed the base as much as possible, to minimize the torque. Removed the inner plastic and designed a TPU insert instead.

Thank you @MORON!

Feel free to modify it to your needs!

PLA will not stand a chance! Currently printing it via PA6-CF