Fanatec CSL Load Cell spring limiter - Pressure point simulation
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This limiter simulates the feeling of the pressure point of the brake system.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 81
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
On my research and several tries of getting a satisfying feeling and feedback of the Fanatec's CSL Load Cell I ended up with that solution. I was missing the feeling of the pressure point of a real brake of a car and this one comes very close.
Two metal springs are needed. One with very less force which is limited in most of its movement to simulate the the feeling, when the brake pads are reaching the brake disks and the pressure point starts. The other spring must have bit more of force which simulates the actual brake action and force. The strong spring is sligtly limited by a TPU ring which gives a better feedback and reduces mechanical sound from the pedal.
In my set the yellow one was the most lite, followed by the blue one which had more force.
I bought my set of 4 springs from a private person and do not know the spring's forces but I think the commonly offered springs (e.g., Ebay, Amazon) might be are around similar forces.
Amount | Part | Info |
|---|---|---|
LoadCell_SpringLimiter_16mm | 1 | To be printed in filament that can take more mechanical load such as PETG. |
LoadCell_SpringLimiter_TPU_11.5mm | 1 | To be printed in TPU. I used Polymaker Polyflex 95A filament, 20% triangles infill, 3 perimeters and 3 horizontal layers. |
Very Lite force spring | 1 | |
Lite force spring | 1 |
For mounting, parts of the original set is needed. Mount it together as shown on the pictures. The TPU Ring "LoadCell_SpringLimiter_TPU_11.5mm" must be on the site of the lite spring and the "LoadCell_SpringLimiter_16mm" must be set on the side of the very lite force spring.
The whole unit is must be compressed to dissasemble and assemble it. A certain amount of force in the hands are needed for it. Please be aware of your finger to not jam and hurt them!
If you have any comments, suggestions or similar, you are welcome to contact me.