Airsoft Picatinny Riser (With Recoil Lugs)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Picatinny riser with recoil lugs and a clamping mechanism to hold it firmly to the picatinny rail.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 118
- Wydruki
- 0
- Wyświetlenia
- 396
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial
Dot height is lifted 13.35mm (0.526in). There were no picatinny risers that I could find online that had the features I wanted in a printable picatinny riser, looked cool, and were also free. This picatinny riser (both the small and large versions) have recoil lugs (useful for airsoft gas blowback rifles) as well as a special clamp design that will clamp the picatinny riser to the rail and hold it tight. This is achieved through a small ridge on the clamp that will press the riser downward, ensuring no wobble of the optic during the cycling of whatever you mount this on. Some post - processing will probably need to be done on the recoil lugs for proper fitment. The following parts are required for assembly:
2x M4 button head cap screws, 30mm in length
2x M4 nuts
Notes:
The recoil lugs need to be supported from the very bottom. I included print files with custom support added, however I found that tree support also works well.
The risers and clamps should print with the large 45 - degree angled portion on the bed.
The M4 screws can be slightly cut down to fit the mount better but I haven't found this to be necessary.
This riser has been tested on my Tokyo Marui MWS and has held up excellently.
Printed with Fusion Filaments HTPLA+.