Adapter Player One FHD-OAG MAX (Camera Side) to T2 Male
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adapter for fitting FHD-OAG MAX to T2 female connectors.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 43
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Physics & Astronomy
- Licencja
- Creative Commons — Attribution
Adapter for the camera/viewing side of Player One's FHD-OAG MAX to T2 (M42-0.75) male threads. Specifically designed for fitting the OAG to ZWO's 8x31mm EFW without needing an M54 to T2 adapter train. Optimized for resin printing. Printed in grey for testing, obviously recommend using the most matte black you have.
Split design is adjustable in 5 degree increments.
0.5mm @45 degree baffles on interior, flat side facing towards the OAG. Recommend minimizing contact with interior to avoid damaging them.
Strongly recommend using the split design, unless you have some other reason it can't be used. Baffles are better oriented, the alignment pegs can be printed with that orientation, and the vacuum prevention holes are not aligned, further reducing light transmission paths (the path in the single piece file is blocked by screws only).
If using the extended split design, the sleeve must be used as well. Without the sleeve there is no pulling force to keep the insert and body joined, greatly weakening the design.
Fits using hardware provided by Player One (M2.5*7 [x6]).
Assembly steps for split design:
1. Print, clean, and finish curing parts.
2. Place insert into body, then firmly screw into EFW or other T2 female threads.
3. Mark which position on the insert points the direction you want the OAG to point.
4. Remove from EFW, pop out the insert, and place the insert into the body so your mark points towards the flat end of the body.
4a. If desired, prior to replacing the insert add glue of choice to join pieces permanently. Take caution to not get glue on T2 threads while assembling.
5. If using extended version, place sleeve around extension. Strengthens the extension and is required to pull the insert into the body when being used. Do not glue sleeve in place unless it sets under compression, being able to push into the body is vital to stability.
Shout out to sbuerger for non-standard threads in Fusion 360: https://www.printables.com/model/247411-photo-thread-library-for-autodesk-fusion