Arducam Day/Night Camera Case

I wanted to monitor my prints day or night and found the night mode on this camera was worked great for my purposes. I wanted to mount it in the printer enclosure and have the ability to move and reposition it.

the camera runs a bit warm so i added a heat sink and cooling vents to the case to allow for plenty of air flow.

the main case can be easily taken apar and adapted to other mounting methods 

SETTINGS

• Printed with Prusament PLA

• 0.1mm layer height

• 20% infill

• supports and brim 

BOM

• 1 x Base

• 1 x Cap

• 1 x Bracket

• 1 x Arducam: •https://www.amazon.com/dp/B0829HZ3Q7?ref=ppx_yo2ov_dt_b_fed_asin_title

• 1 x Heat Sink: https://www.amazon.com/dp/B08HM3R4KP?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_2&th=1

• 4 x M2 x 6mm Cap Screw

• 2 x M3 x 12mm Cap Screw

• 4 x M3 x 20mm Cap Screw

• 4 x M3 Washer

ASSEMBLY

1. Insert the nuts into the holes and using the screw to seat them in the base and cap.

2. Attach the heat sink to the back roughly centerd

3. insert the connector through the base and connect to the board

4. Secure the arducam with the 4 M2 x 6mm screws to the base, careful to not overtighten

5. Alight the LEDs, Photo Sensore and camera and secure the cap to the base with the 4x M3 x 20mm Screws.

6. Secure the bracket to the mounting surface (wherever you plan to put it)

7. Secure the case to the bracket with the 2 x M3 x 12mm Screws and 4 x M3 washers