Portable Glove80 Tenting v2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
An new version of my glove80 tenting solution. This version uses a bayonet-type connector to attach the tenting legs to the frame of the tenting kit instead of magnets.
As with the previous version, 10 mm x 3 mm rubber-feet are recommended and their height is taken into account in the overall height. Corresponding slots to prevent them from slipping are at the bottom of the frame. The tenting works without, but will be less stable and slide more.
The legs are labeled at the bottom with their respective position and the tenting angle they provide. Legs need to be printed twice and fit both halves.
As it was requested on my other tenting set, versions with non-detachable legs are also available in the fused-folder.
When disassembled, the kit fits into the moergo case.
Provided angles are: 12º, 15º, 18°, 20º, 25° and 30°.
The angle in the images is 12 degrees.