Upper Cooling Case For Minisforum MS-R1

🟩 🟦 🟦 🟪 🟥 🟧 🟨

This is a case for the Minisforum MS-R1 that adds an upper cooling fan. The computer slides and locks in, like in the original case. You will need to fit your own connector probably to your fan, and get the non-standard pin-out correct to make it work.

For this model you need:

• 4 pin 140mm fan (or smaller one with an adapter)

• 4x M4 or M4S inserts

• 8x M3 or M3S inserts

• 4x M4x30 screws

• 8x M3x8 screws and washers

All the insert holes are in the top of the case. Take care to not connect the M4x30 screws too tightly and snap the corners of the fan off.

If you like my designs or find them useful it would be great if you can support me by joining my club on Printables for at least a month, which gives you access to various extra models for the duration of membership. Another alternative is to buy me a coffee over at ko-fi via this link. Thank you!

🟩 🟦 🟦 🟪 🟥 🟧 🟨