1 / 4
Rancilio Silvia v6 v6E water outlet spout — zdjęcie 1
1 / 4

Rancilio Silvia v6 v6E water outlet spout

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Water outlet spout for corrosion protection, without blockage to the drip tray.

Ocena
0 / 5
Polubienia
1
Pobrania
27
Wydruki
0
Wyświetlenia
169
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Even with the silicone mod protection at the seam, if the drip tray is not pushed all the way back, water can run behind the base plate and cause the Silvia to rust. This nozzle guides the water into the tray, even if the tray is positioned slightly forward.

I used three 2.5x160 mm cable ties to secure it. You can use any length that is long enough to wrap around the part, but the width must be 2.5 mm.

Fasten the cable ties as shown in the pictures, alternating from right to left and hooking them onto the 3D-printed part.

Because the tolerances are tight, make sure the stock black spout is fully screwed in before installing this.

If installed correctly, you will not need to move or remove it in order to take out the drip tray.

I designed this for my Rancilio Silvia 6E with the red pump. It may also fit other versions.

Tagi