1 / 7
Shower Hair Catcher — Drop-In Cup with Magnet Pocket — zdjęcie 1
1 / 7

Shower Hair Catcher — Drop-In Cup with Magnet Pocket

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Drop-in cup-style shower / bath / sink drain hair catcher. Open-top cup, fine hex bottom strainer, captive Ø16 mm magnet

Ocena
0 / 5
Polubienia
3
Pobrania
13
Wydruki
0
Wyświetlenia
64
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Bathroom
Licencja
Creative Commons — Attribution

Drop-in cup-style shower hair catcher that sits inside a typical EU bathroom / shower / sink drain and stops hair before it clogs the trap. One-piece print, no hardware, no supports.

Default size: Ø43 mm cup body, Ø56 mm top brim flange, 5 mm deep into the drain, ~7.8 mm overall Z. Sits on the drain rim (brim) with the body dropping into the drain hole. Open top — water flows straight into the bowl.

Strainer pattern. Fine hex grid across the whole bottom plate (2.5 mm flat-to-flat cells, 0.9 mm walls) lets water through while trapping hair. Nothing blocks the middle, so the full footprint drains.

Fibre hooks. Twelve rounded posts stand on the floor in two staggered rings. Long hairs drifting toward the grid catch on them instead of threading through a cell, which is what actually keeps fine hair out of the trap.

Cleaning. Lift the cup out by the rim, rinse the hair off the bottom hex, drop it back in. It seats on its own weight; nothing to unclip.

Parametric. Edit the top of shower_hair_catcher.scad to retune: catcher_d for brim OD (38 / 50 / 56 / 75 / 90 mm presets in the header), body_d for cup OD, body_h for cup depth into the drain, post_hole_d if your drain has a centre stem the cup must sit over.

The photo gallery shows the cup top-down, the hex underside, and the part installed in a real shower drain.

Tagi