Shower Hair Catcher — Drop-In Cup with Magnet Pocket
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Drop-in cup-style shower / bath / sink drain hair catcher. Open-top cup, fine hex bottom strainer, captive Ø16 mm magnet
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 13
- Makes
- 0
- Views
- 64
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Bathroom
- License
- Creative Commons — Attribution
Drop-in cup-style shower hair catcher that sits inside a typical EU bathroom / shower / sink drain and stops hair before it clogs the trap. One-piece print, no hardware, no supports.
Default size: Ø43 mm cup body, Ø56 mm top brim flange, 5 mm deep into the drain, ~7.8 mm overall Z. Sits on the drain rim (brim) with the body dropping into the drain hole. Open top — water flows straight into the bowl.
Strainer pattern. Fine hex grid across the whole bottom plate (2.5 mm flat-to-flat cells, 0.9 mm walls) lets water through while trapping hair. Nothing blocks the middle, so the full footprint drains.
Fibre hooks. Twelve rounded posts stand on the floor in two staggered rings. Long hairs drifting toward the grid catch on them instead of threading through a cell, which is what actually keeps fine hair out of the trap.
Cleaning. Lift the cup out by the rim, rinse the hair off the bottom hex, drop it back in. It seats on its own weight; nothing to unclip.
Parametric. Edit the top of shower_hair_catcher.scad to retune: catcher_d for brim OD (38 / 50 / 56 / 75 / 90 mm presets in the header), body_d for cup OD, body_h for cup depth into the drain, post_hole_d if your drain has a centre stem the cup must sit over.
The photo gallery shows the cup top-down, the hex underside, and the part installed in a real shower drain.
