Power supply cable organizer for pedal boards
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Power supply cable organizer for pedal boards
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 106
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Designed for players frequently re-organizing their signal chain.
Can be used to route the power cables where they need to go and hold the extra slack in place.
Snug fit - the cables are held in a tight grip, will not fall out due to shaking or vibration.
For best results, put the cable into the top of the holder by spreading the 'lips' with your fingers, and then push the cable down using a guitar pick.
Length = 50 mm
Width = 20 mm
Height = 20 mm
Recommended clearance between the floor and the bottom of the underside of the board = 25mm or more
Designed to be mounted using two M3 x 16 wood screws. If your board is made of metal, use some good double-sided tape instead.