IKEA BESTÅ Wall Mount Support Bracket — Shallow 20cm Cabinets — M8

## IKEA BESTÅ Wall Mount Support Bracket — Shallow (20cm) Cabinets

Supplementary wall-mount bracket for IKEA BESTÅ shallow (20cm depth) cabinets. Bolts directly into the cabinet's factory-drilled M8 hole — no modification required.

Designed as added support alongside the IKEA wall suspension system, not as a structural replacement.

### Verified compatibility

- IKEA BESTÅ frame 60x20x64 cm article 60245919

- Likely fits other BESTÅ variants with the same factory M8 hole pattern — verify hole position before printing.

### Installation

- Cabinet attachment: M8 × 25 mm max screw — factory hole is pre-threaded, no nut required.

M8 × 30 mm physically fits but is tight in the bracket recess; 25 mm gives clean fit.

- Wall attachment: 2 countersunk screws per bracket — use wall plugs appropriate for your wall type

- Recommended: 2 brackets per cabinet (left + right)

### Print settings

- Material: ASA, PETG, or PC — load-bearing application, avoid PLA

- Perimeters: 4+

- Infill: 50%+

- Layer height: 0.2 mm

- Supports: not required (print flat on triangular face)

### ⚠ Use at your own risk

This is a 3D-printed supplementary support bracket, not a certified structural component. BESTÅ cabinets with contents can weigh 20–40 kg. Primary wall attachment should rely on IKEA's original suspension hardware — this bracket adds support, not replaces it. Test under load before trusting with valuables. The designer accepts no liability for damage, falling cabinets, injury, or property damage. You are responsible for safe installation.